日本油研壓力控制閥,YUKEN壓力控制閥效果圖
如果您對該產品感興趣的話,可以
產品名稱: 日本油研壓力控制閥,YUKEN壓力控制閥效果圖
產品型號:
產品展商: YUKEN-油研
產品文檔: 無相關文檔
簡單介紹
日本油研壓力控制閥,YUKEN壓力控制閥效果圖
the handle slowly clockwise for higher pressures or anti-clockwise
for lower pressures. After adjustments, do not forget to tighten the lock nut.
Piping of the tank line should not be connected to any
tank line of the other valves, but connected directly to the tank.
日本油研壓力控制閥,YUKEN壓力控制閥效果圖
日本油研壓力控制閥,YUKEN壓力控制閥效果圖
的詳細介紹
日本油研壓力控制閥,YUKEN壓力控制閥效果圖
手柄對于較*的壓力順時針順時針或逆時針
對于較低的壓力。 調整后,不要忘記擰緊鎖緊螺母。
油箱管路的管道不應連接任何
其他閥門的油箱管路,但直接連接到油箱。
Sy nthetic fluids
Water containing fluids
Use fluids equivalent to ISO VG 32 or VG 46.
Use phosphate ester or poly ol ester fluid. When phosphate ester fluid is used,
prefix "F-" to the m odel number because the special seals (fluororubber) are required to be used.
Use water-gly col fluid.
To adjust the pressure, loosen the lock nut and turn
Petroleum base oils
用等同于ISO VG 32或VG 46的流體。
使用磷酸酯或聚醇酯流體。 當使用磷酸酯流體時,
因為需要使用特殊密封(氟橡膠),所以前綴“F-”表示數字。
使用水 - 糖液。
可以使用下表中列出的任何類型的液壓油。
Any type of hydraulic fluids listed in the table below can be used.
Note:
For use with hy draulic fluids other than those listed above,
please consult y our Yuken representatives in advance.
the handle slowly clockwise for higher pressures or anti-clockwise
for lower pressures. After adjustments, do not forget to tighten the lock nut.
Piping of the tank line should not be connected to any
tank line of the other valves, but connected directly to the tank.
注意:
對于除上述以外的液壓流體使用,
日本油研壓力控制閥,YUKEN壓力控制閥效果圖